yongnuo help

Discussion in 'General Discussion' started by Alan, Jul 8, 2008.

  1. Alan

    Alan

    385
    May 9, 2008
    Georgia
    Has anyone dealt with the Yongnuo remote for a D200 (YN-128)? I recieved one from Hong Kong today and the reciever is not working out of the box. I installed the battery and made sure Tx and RX were set to the same(all). It appears dead. Any suggestions?
     
  2. Alan

    Alan

    385
    May 9, 2008
    Georgia
    ok, I feel alittle stupid here. Which menu tells the d200 that I am using a remote trigger. I have searched and cannot find it...
     
  3. Alan

    Alan

    385
    May 9, 2008
    Georgia
    OK, I got it working. Mostly stupidity on my part.
     
  4. DrewC

    DrewC

    Jan 30, 2007
    Denver, CO
    why dont you detail what was going wrong if you figured it out... it sounds like you're trying to mix CLS and RF triggers from what i gathered...
     
  5. Alan

    Alan

    385
    May 9, 2008
    Georgia
    As I said, mostly stupidity. It was actually working and I did not know it. I THOUGHT I needed to go into one of the menus and tell it I was using a remote trigger, but I did not need to.